Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
In this case, the push-button extension module is completely disabled during disabling.
Pressing a button has no effect. The status LEDs of the disabled buttons are without
function (no button-press display either). Only the "Always ON" or "Always OFF" state
remains unaffected by the disabling function.
o Set the parameter "Behaviour during active disabling" to "all buttons behave like". Also set
the parameters "All buttons with even / odd numbers behave during disabling like" to the
desired module button number or disabling function.
All buttons behave as defined in the parameters for the two specified reference buttons of
the push-button extension module. For all control buttons with an even number (2, 4, 6, …)
and for all buttons with an odd number (1, 3, 5, …) it is possible to program not only
different reference buttons, but also identical reference buttons. The two "virtual" disabling
functions can also be configured as a reference button.
The telegrams are transmitted to the bus via the communication objects of the specified
reference buttons. The status LEDs of the reference buttons are controlled according to
their function. The status LEDs of the disabled buttons are without function (no button-
press display either). Only the "Always ON" or "Always OFF" state remains unaffected by
the disabling function.
o Set the parameter "Behaviour during active disabling" to "Individual buttons without
function". In the "Disable -> Disable - Button selection" parameter node, specify the buttons
to which the disable is to apply.
Only the individually specified buttons are locked during disabling. The other control
buttons remain unaffected by disabling. The status LEDs of the disabled buttons are
without function (no button-press display either). Only the "Always ON" or "Always OFF"
state remains unaffected by the disabling function.
o Set the parameter "Behaviour during active disabling" to "Individual buttons behave like". In
the "Disable -> Disable - Button selection" parameter node, specify the buttons to which the
disable is to apply. Also set the parameters "All buttons with even / odd numbers behave
during disabling like" to the desired module button number or disabling function.
Only the individually specified buttons behave as defined in the parameters of the two
specified reference buttons of the push button extension module. For all control buttons
with an even number (2, 4, 6, …) and for all buttons with an odd number (1, 3, 5, …) it is
possible to program not only different reference buttons, but also identical reference
buttons. The two "virtual" disabling functions can also be configured as a reference button.
The buttons that will be disabled are defined in the parameters under "Disable -> Disable –
Buttons selection".
The telegrams are transmitted to the bus via the communication objects of the specified
reference buttons. The status LEDs of the reference buttons are controlled according to
their function. The status LEDs of the disabled buttons are without function (no button-
press display either). Only the "Always ON" or "Always OFF" state remains unaffected by
the disabling function.
i If a button evaluation is taking place at the time of activation / deactivation of a disabling
function, this function is aborted immediately and with it also the pertaining button function.
It is first necessary to release all buttons before a new button function can be executed if so
permitted by the state of disabling.
Page 165 of 347
Software "Smart Control 501511"
Functional description

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English