Art. No. SC 1000 KNX
Yes
No
A status text, which visualises different
texts (e.g. "Off" / "On" or "Absent" /
"Present") in the display depending on
the object value of the switching status
feedback ("0" / "1"), can be displayed
optionally below the text name. The
parameters "Status text for object value
0" and "Status text for object value 1"
define which status text is displayed.
This parameter defines the visibility of
the status text in the display element of
the channel.
After a device reset, the display shows
"---" until a feedback object value of the
status text is received.
Status text for object
value 0
Off, free text with a max. of
12 characters
This parameter defines the status text
for the value "0" of the channel switching
object. A text with a maximum of 12
characters can be entered.
The parameter is only visible when a
status text is to be displayed.
Status text for object
value 1
On, free text with a max. of
12 characters
This parameter defines the status text
for the value "1" of the channel switching
object. A text with a maximum of 12
characters can be entered.
The parameter is only visible when a
status text is to be displayed.
Surface evaluation Button function (single
surface)
Rocker function (double
surface)
The operating element of the channel
can be evaluated optionally on the touch
surface as a rocker switch (double-
surface principle) or as a button (single
surface principle). This parameter
defines the sensor evaluation and thus
specifies the character of the sensor
element in the display.
In the button function, a further
parameter opens in the plug-in. The
operating element can be touched
anywhere. The preset push-button
function will then always be executed.
With the rocker function, the operating
element is divided into two sensor
areas. These sensor areas are one
above the other and must be operated
separate from each other. It is not
permissible to operate both sensor
areas of a rocker simultaneously.
Command on pressing
the button
no function
ON
OFF
TOGGLE
This parameter is only visible when the
"Surface evaluation" parameter is
configured to "Button function (single
surface)". The function is configured on
pressing the button. When pressing a
button, either an ON, an OFF or a
TOGGLE telegram can be transmitted to
Page 255 of 347
Software "Smart Control 501511"
Parameters