Art. No. SC 1000 KNX
Value transmitter levels 5%
10%
15%
20%
25%
are not to be transmitted
during adjustment
Brightness value telegrams are
transmitted to the bus gradually in a
defined time interval by means of long
operations of the sensor surfaces + or -.
The device then increases or decreases
the value cyclically during the operation
depending on the value transmitter level
configured here and transmits the
values as a brightness setting. The
value sequence generated in this way is
converted to a dimming process by the
activated dimmer actuator.
In the setting "not to be transmitted
during adjustment", the value
adjustment is deactivated by a long
button-press.
Time between two value
telegrams
500ms
1s
2s
3s
This parameter defines the time
between two value telegrams on a long
button-press. The time must be attuned
as much as possible to the dimming
speed of the dimmer actuator in order to
attain a constant and interruption-free
dimming process during the value
adjustment.
Activate keyboard on
pressing the status
value (brightness)
Yes
No
In addition to the possibilities of
specifying a brightness value using the
sensor surfaces + / - or slider, a
keyboard can optionally be shown in the
display. It is possible to specify a
brightness value directly using the
keyboard. The keyboard becomes
visible by pressing your finger on the
display area (long press approx. 1s) if
this was also enabled here (setting:
Yes). If the setting is "No", a long
operation of the display area shows no
response.
The following parameters are only visible for the function "Venetian blind/shutter (Step/Move/
Step)"...
Shadow Venetian blind
Shutter
The KNX channel can be adapted to the
shading system type by this parameter.
It is possible to configure "Venetian
blinds" incl. slat control whereby vertical
slat systems are also controllable or
alternatively "roller shutters" whereby
window drives or awnings are also
controllable. To simplify the control, no
slat functions are available in the rolling
shutter shading method, which is why
the slat adjusting time, among other
things, is omitted. In this case, the
selectable status icons are also
adapted.
Page 258 of 347
Software "Smart Control 501511"
Parameters
To Next Page
Loading...
Need help?
General
