Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
Switching value ON/Lowering
OFF/Raising
Depending on the function of the
allocated KNX channel, the switching
time executes a channel command
when executing a switching time. This
parameter defines which channel
command should be executed for the
channel functions "switching", "dimming
(Start/Stop)" and "Venetian blind/shutter
(Step/Move/Step)".
The ETS parameters "switching value",
"1-byte switching value" and "2-byte
switching value" are always visible. The
function of the allocated KNX channel
defines which of these parameters is
enabled In the channel functions "scene
extension" and "operating mode
switchover internal" none of the
aforementioned parameters are
enabled. In these cases, the channel
command of the timer is specified
directly by the configuration of the KNX
channel.
1-byte switching value 0...255 Depending on the function of the
allocated KNX channel, the switching
time executes a channel command
when executing a switching time. This
parameter defines which channel
command should be executed for the
channel functions "dimming (brightness
value)", "Venetian blind/shutter
(position)" and "1-byte value
transmitter".
The ETS parameters "switching value",
"1-byte switching value" and "2-byte
switching value" are always visible. The
function of the allocated KNX channel
defines which of these parameters is
enabled In the channel functions "scene
extension" and "operating mode
switchover internal" none of the
aforementioned parameters are
enabled. In these cases, the channel
command of the timer is specified
directly by the configuration of the KNX
channel.
2-byte switching value -671088.64...
0.0
...670760.96
Depending on the function of the
allocated KNX channel, the switching
time executes a channel command
when executing a switching time. This
parameter defines which channel
command should be executed for the
channel functions "2-byte value
transmitter" and "setpoint shift, internal".
The value that the user enters in the
entry field is converted by the ETS
PlugIn to the KNX data type 9.0xx
Page 282 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English