Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
(floating-point numbers) and written in
the ETS database. This can result in
value adjustments due to rounding.
In the channel function "setpoint shift
internal", it should be noted that the
device only accepts values within the
value range of the setpoint shift
(-4...0...+4). Entered values which
contain decimal places are rounded to
the nearest whole number, of course.
The ETS parameters "switching value",
"1-byte switching value" and "2-byte
switching value" are always visible. The
function of the allocated KNX channel
defines which of these parameters is
enabled In the channel functions "scene
extension" and "operating mode
switchover internal" none of the
aforementioned parameters are
enabled. In these cases, the channel
command of the timer is specified
directly by the configuration of the KNX
channel.
h Display -> Timer -> Switching time 2...8 like switching time 1!
Page 283 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English