Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
the lower limit of the adjustment range
(0 or 0 %) or if it exceeds the upper limit
(255 or 100%), the sensor adapts the
step width of the last step automatically.
Visible only if "Value adjustment by long
button-press = enabled"!
Value adjustment with
overflow
Yes
No
If value adjustment is to be effected
without overflow (setting "No") and if the
pushbutton sensor reaches the lower
limit of the adjustment range (0 or 0 %)
or the upper limit (255 or 100 %) during
value adjustment, the adjustment will be
stopped automatically by the sensor.
If the value adjustment with overflow is
programmed (setting "Yes") and if the
push button sensor reaches the lower or
the upper limit, it will transmit the value
of this range limit and then add a pause
the duration of which corresponds to two
levels. Thereafter, the push button
sensor transmits a telegram with the
value of the other range limit and
continues the value adjustment in the
same direction.
The following parameters are only visible for the push-button function "Value transmitter 2
byte"...
Function Temperature value
transmitter
Brightness value
transmitter
Value transmitter
(0...65535)
A button configured as "Value
transmitter 1 byte" permits selecting
whether the values to be transmitted are
to be interpreted as temperature values
(0 °C to 40 °C), as brightness values
(0 lux to 1500 lux) or as integers
(0 to 65535). The following parameters
and their settings depend on this
selection.
Temperature value
(0...40 °C)
0...20...40 This parameter defines the object value
when the button is pressed. Visible only
if "Function = Temperature value
transmitter"!
Brightness value 0, 50,...300...1450, 1500
Lux
This parameter defines the object value
when the button is pressed. Visible only
if "Function = Brightness value
transmitter"!
Value (0...65535) 0...65535 This parameter defines the object value
when the button is pressed. Visible only
with "Function = Value transmitter
(0...65535)"!
Page 329 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English