Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
i You must not move your finger to hastily to switch over a display page. When positioning
your finger on the glass surface, no areas containing operating elements should be
touched if possible. This can cause operating commands to be executed if you keep your
finger pressed down without moving it left or right. The lower edge of the display normally
allows you to switch over display pages.
i Not only can display pages of the main menu level be switched over by finger-touch-screen
operation. Is is also possible to switch over on many lower level display pages by finger-
touch-screen operation (e.g. room operation).
Figure 15: Example of switching over display pages by finger-touch-screen operation (switching
over between start screen and favourite screen)
Alternatively, it is also possible to navigate through the display pages of the main menu level
using two sensor buttons located outside the display area.
The sensor buttons...
V Return to the start page or to the first display page (if no start page is available)
and
U (Scrolling in the main menu level)
...make it easier to navigate through the display pages and can be used alternatively for finger
operation of the graphic interface (figure 16).
Page 69 of 347
Software "Smart Control 501511"
Functional description

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English