Juniper ACX7348 - Page 49

Table 16: FPC Status LEDs (Connued)
LED Color State Descripon
Unlit O The FPC is disabled or oine.
Table 17 on page 41 describes the network port LEDs.
Table 17: Network LEDs
Color State Descripon
Unlit O A transceiver is not present in the
port, or the link is down because of
signal loss.
Green On steadily A link is established.
Amber On steadily The link is down because of a
remote error or because the port
was disabled through the CLI.
Red On steadily The port has a hardware failure or
the link is down.
41