Juniper AP32 User Manual

Table 12: Troubleshoot AP Disconnecon Issues (Connued)
LED Color Blink Paern Issue Steps to Troubleshoot
Blinking yellow ve mes The default gateway IP
address is congured but
the AP is unable to
connect to the default
gateway.
1. Verify that the default
gateway IP address is
set correctly in all the
conguraons on the
switch port (VLAN,
nave VLAN) and the
DHCP pool
conguraon.
2. If you've congured a
stac IP address for
the AP, check whether
the default gateway is
congured correctly.
If the default gateway
is not congured
correctly, follow these
steps:
a. Power o the AP
by shung down
the PoE on the
switch port to
which the AP is
connected.
Alternavely, you
can remove the
physical cable that
provides power to
the AP.
b. Correct the
conguraon on
the switch port.
c. Reset the AP to the
factory-default
conguraon. See
"Reset an Access
66

Juniper AP32 Specifications

General

Brand	Juniper
Model	AP32
Category	Wireless Access Point
Language	English