Required Tools 11
Chapter 2
Installing the EX2500 Ethernet Switch
This chapter describes how to install and initialize the EX2500 switch:
Required Tools on page 11
Package Contents on page 12
Environmental Requirements on page 12
Installing the EX2500 Switch in a Standard Equipment Rack on page 14
Installing the EX2500 Switch in a 4-Post Rack on page 15
Connecting Power to the EX2500 Ethernet Switch on page 18
Initializing the EX2500 Ethernet Switch on page 18
Using the Boot Management Menu on page 20
Installing and Removing an SFP+ Optical Transceiver on page 21
Troubleshooting on page 22
Required Tools
You need the following tools or equipment to successfully accomplish the
installation procedures in this document:
Standard flat-blade screwdriver
Number 2 Phillips screwdriver
Electrostatic discharge wrist strap
To Next Page
Loading...
