EX2500 Ethernet Switch Hardware Guide
38 EX2500 Compliance Statements
EX2500 Compliance Statements
This section contains the following regulatory compliance statements for the
EX2500 Ethernet Switch:
Federal Communications Commission (FCC) Statement on page 38
Industry Canada Class A Emission Compliance Statement on page 39
Australia and New Zealand Class A Statement on page 39
European Union EMC Directive Conformance Statement on page 39
Japanese Voluntary Control Council for Interference (VCCI) Statement on
page 39
Denan Statement (Japan/Nippon Only) on page 40
Federal Communications Commission (FCC) Statement
VORSICHT—Kategorie 1 Laser Produkt
Schauen Sie nicht direkt in einen Glasfaserlautsprecherempfänger oder in der
offene Ende der Glasfaserkabel.
Glasfasertransciever und Glasfaserkabel an einen Transciever angeschlossen
strahlen Laserlicht aus, das Ihre Augen beschädigen kann.
Lassen Sie nicht einen Glasfasertransciever unbedeckt, wenn Sie Kabel
einsetzen oder entfernen. - der Sicherheitsverschluß hält das Port sauber und
verhindert versehentliche.
Ausstrahlung vom Laserlicht. Kontrollieren Sie und säubern Sie die LC
Stecker-Ende, bevor Sie irgendwelche Verbindungen durchfuehren.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission
limits. Juniper Networks is not responsible for any radio or television interference caused by using
other than recommended cables and connectors or by unauthorized changes or modifications to this
equipment. Unauthorized changes or modifications could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
To Next Page
Loading...
Need help?
General
