Chapter 8 Set Up Geode Connect for Windows PC 111
Owner's Manual
Geode Connect will attempt to repair the connection.
If Geode Connect is unable to repair the connection, you
may need to turn the Geode off and on again and/or go
to Windows Settings and select Forget Device for the
Geode you are trying to pair. After doing so, return to Geode
Connect and begin the pair sequence for a Bluetooth
connection again.
Connect via USB
The Geode can connect with a Windows PC or handheld
tablet—such as the Juniper Systems Mesa 3 Windows—
using the supplied USB cable.
1. Ensure your Windows PC or tablet is in Desktop mode,
not Tablet mode.
2. Power on the Geode before you plug it into your device.
3. Plug the USB cable into your device and the Geode.
Note: This may cause the red LED Status Indicator to flash
rapidly on the Geode because there is not enough power in
the PC or handheld device to charge the Geode. This does
not affect the data transfer between the Geode and the
device.
4. Open Geode Connect.
If the device has connected to a Geode previously, tap the
Geode name at the top of the screen.
The app will ask you what you would like to do.
Note: If the device has not previously connected to a Geode,
the app will immediately open the Device Setup page
when you open the app.
To Next Page
Loading...