Juniper JUNOSE 11.2.X MULTICAST ROUTING - Page 123

host1:pe1:pe13(config-route-map)#match ip address pe13DataMdtSend
host1:pe1:pe13(config-route-map)#set threshold 0
host1:pe1:pe13(config-route-map)#route-map pe13MdtThresholds permit 20
host1:pe1:pe13(config-route-map)#match ip address pe13DataMdt
host1:pe1:pe13(config-route-map)#exit
7. Configure the data MDT.
host1:pe1:pe13(config)#ip pim data-mdt
host1:pe1:pe13(config-ip-pim-data-mdt)#tunnel source 1.1.1.1
host1:pe1:pe13(config-ip-pim-data-mdt)#tunnel group-address-pool pe13DataMdtG$
host1:pe1:pe13(config-ip-pim-data-mdt)#route-map pe13MdtThresholds
ip pim data-mdt
• Use to activate data MDTs and enter IP PIM Data MDT Configuration mode.
• Example
host1(config)#ip pim data-mdt
• Use the no version to deactivate data MDTs.
• See ip pim data-mdt.
ip pim group-address-pool
• Use to configure PIM group address pools from which data MDT group addresses are
allocated.
• Example
host1(config)#ip pim group-address-pool pe21DataMDT 232.1.0.0 232.2.255.255
• There is no no version.
• See ip pim group-address-pool.
mdt-data-delay
• Use to configure a delay before switching to data MDT.
• The delay is measured by 0.1 seconds; the default is 30.
• Example
host1(ip-pim-data-mdt-config)#mdt-data-delay 20
• Use the no version to return to the default.
• See mdt-data-delay.
mdt-data-holddown
• Use to configure the time in seconds before switching to the default MDT group from
the data MDT group.
• The default is 60.
• Example
host1(ip-pim-data-mdt-config)#mdt-data-holddown 200
101Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring PIM for IPv4 Multicast