Juniper JUNOSE 11.2.X MULTICAST ROUTING

• Use the no version to return to the default.
• See mdt-data-holddown.
mdt-data-timeout
• Use to configure the time in seconds before the flow leaves the data MDT group.
• The default is 180.
• Example
host1(ip-pim-data-mdt-config)#mdt-data-timeout 160
• Use the no version to return to the default.
• See mdt-data-timeout.
mdt-interval
• Use to configure the time in seconds between successive MLD join TLV messages.
• The default is 60.
• Example
host1(ip-pim-data-mdt-config)#mdt-interval 80
• Use the no version to return to the default.
• See mdt-interval.
set threshold
• Use to configure a threshold value for multicast VPN applications, including default
MDT and data MDT.
• Example
host1(config)#set threshold 30
• Use the no version to remove the threshold.
• See set threshold.
tunnel group-address-pool
• Use to configure a group address pool for a data MDT tunnel.
• Example
host1(ip-pim-data-mdt-config)#tunnel group-address-pool dataMDT1
• Use the no version to delete the group address pool.
• See tunnel group-address-pool.
Copyright © 2010, Juniper Networks, Inc.102
JunosE 11.2.x Multicast Routing Configuration Guide