Juniper JUNOSE 11.2.X MULTICAST ROUTING User Manual

Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:04:12/never
Counts: 2 (S, G) entries
0 (*, G) entries
• See show ipv6 mroute.
show ipv6 mroute active
• Use to display the active multicast routes with admission bandwidth greater than the
specified bandwidth threshold.
• The default is 4000 bps.
• Field descriptions
• See the show ipv6 mroute command and the show ipv6 mroute summary
command for descriptions of all fields.
• Example 1—Displays active multicast routes with bandwidth above 10000 bps
host1#show ipv6 mroute active 10000
Active IP Multicast Routes >=10000 bps
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(52::1, ff3e::1) uptime 0 00:01:07
Admission bandwidth: 47000 bps (adaptive)
QoS bandwidth: 47000 bps (adaptive)
RPF route: 52::/112, incoming interface ATM2/1.17
neighbor 17::2, owner NetmgmtRpf
Incoming interface list:
ATM2/1.17 (fe80::90:1a00:3140:1ff8/128), Accept/MLD (RPF IIF)
Outgoing interface list:
NULL
Counts: 1 (S, G) entries
Copyright © 2010, Juniper Networks, Inc.168
JunosE 11.2.x Multicast Routing Configuration Guide

Juniper JUNOSE 11.2.X MULTICAST ROUTING Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X MULTICAST ROUTING
Category	Software
Language	English