• Types and identifiers of interfaces. For details about interface types and specifiers,
see Interface Types and Specifiers in JunosE Command Reference Guide .
• Protocols configured on the interface and the protocol that owns the interface. If
you configure only MLD on an interface, MLD owns the interface. However, if you
configure MLD and PIM on the same interface, PIM owns the interface.
• Admitted bandwidth / configured admission bandwidth (in bps)
• Number of blocked OIFs
• QoS adjustment bandwidth (in bps)
• Count—Number of multicast protocols on the VR
• Example
host1:2#show ipv6 multicast protocols
Multicast protocols:
Protocol Pim
Type: Sparse
Interfaces: 1 registered, 1 owned
Registered interfaces:
ATM2/1.103 (21:2:2:22::1:2/60) owner Pim
Protocol Mld
Type: Local
Interfaces: 1000 registered, 1000 owned
Registered interfaces:
ATM2/0.131 (31:2:2:22::2:2/604) local Mld owner Mld
Admission-bandwidth 2000000/10000000 bps
QoS Adjust 2000 bps
ATM2/0.132 (31:2:2:22::2:3/60) local Mld owner Mld
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
ATM2/0.133 (31:2:2:22::2:4/60) local Mld owner Mld
Admission-bandwidth 8000000/10000000 bps, 2 Blocked OIFs
QoS Adjust 0 bps
...
Count: 2 protocols
• See show ipv6 multicast protocols.
show ipv6 multicast protocols brief
• Use to display a summary of information about multicast protocols enabled on the
router.
• Field descriptions
• Protocol—Name of the multicast protocol
• Registered Interfaces—Number of interfaces on which the protocol is configured.
• Owned Interfaces—Number of interfaces that a protocol owns. If you configure only
MLD on an interface, MLD owns the interface. However, if you configure MLD and
PIM on the same interface, PIM owns the interface.
• Type—Mode of the multicast protocol
173Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Configuring IPv6 Multicast
To Next Page
Loading...