Juniper JUNOSE 11.2.X MULTICAST ROUTING

• (S,G)—Number of (S,G) entries
• (*,G)—Number of (*,G) entries
• Example
host1#show ipv6 mroute summary
IPv6 Multicast Routing Table
Group Address Source Address RPF route RPF Iif #Oifs
--------------- --------------- ------------------ --------------- -----
ff0e::1 10:0:0:1:1:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:2:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:3:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:4:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:5:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:6:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:7:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:8:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:9:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:a:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:b:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:c:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:d:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:e:: 10:0:0:1::/64 ATM2/3.1001 1
ff0e::1 10:0:0:1:f:: 10:0:0:1::/64 ATM2/3.1001 1
Counts: 16 (S, G) entries
0 (*, G) entries
• See show ipv6 mroute.
show ipv6 multicast protocols
• Use to display information about multicast protocols enabled on the router.
• Use the brief option to display a summary of information rather than a detailed
description.
• Field descriptions
• Protocol—Name of the multicast protocol
• Type—Mode of the multicast protocol
• For PIM—Sparse
• For MLD—Local
• Interfaces
• registered—Number of interfaces on which the protocol is configured
• owned—Number of interfaces that a protocol owns. If you configure only MLD on
an interface, MLD owns the interface. However, if you configure MLD and PIM on
the same interface, PIM owns the interface.
• Registered interfaces—Includes the following information about interfaces on which
the protocol is configured
Copyright © 2010, Juniper Networks, Inc.172
JunosE 11.2.x Multicast Routing Configuration Guide