Counts: 0 down, 0 init state, 1 querier, 0 non-querier, 1 Total
• See show ipv6 mld interface.
show ipv6 mld interface brief
• Use to display a summary of MLD information for interfaces on which you enabled
MLD.
• Field descriptions
• Interface—Type of interface and interface specifier. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
• Intf Address—IPv6 link-local address of the interface
• Ver—MLD version
• State—Function of the interface: querier or nonquerier
• Querier—IPv6 address of the querier on the network to which this interface connects
• QTime—Remaining time interval at which this interface sends query messages
• QPTime—Remaining time that the interface waits before declaring itself as the
querier
• Example
host1:boston# show ipv6 mld interface brief
Interface Intf Address Ver State Querier QTime QPTime
--------------- --------------- --- ---------- ------------- ------ ------
ATM2/0.103 130.0.0.1/24 2 Querier 130.0.0.1 3(7) 0
ATM5/0.102 131.0.0.1/24 2 Querier 130.0.0.1 101(7) 0
Counts: 0 down, 0 init state, 2 querier, 0 non-querier, 2 Total
• See show ipv6 mld interface.
show ipv6 mld mapped-oif
• Use to display the current mappings to all mapped outgoing interfaces or to the
specified mapped outgoing interface.
• Field descriptions
• OIF—Outgoing interface used in an OIF map
• Oper—Operation status of the outgoing interface
• Group Address—Multicast group IP address associated with the OIF
• Source Address—Source IP address associated with the OIF
• Join I/F—MLD protocol interface associated with the OIF
Copyright © 2010, Juniper Networks, Inc.196
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page