Juniper JUNOSE 11.2.X MULTICAST ROUTING - Page 246

• Register TTL—TTL value (in PIM register packets) originated by this PIM router
• SSM—State of SSM on this PIM router (enabled or disabled)
• range—Default SSM group range or name of the access list specifying the range
• Join filter—Name of the join filter access-list (if configured) for this PIM router
• Designated Router Priority—Designated router priority value
• Example
host1:1#show ipv6 pim
Default PIM Version: 2
Default Domain Id: 0
Default Hello Period: 30
Default Hello HoldTime: 105
Join-Prune Interval: 100
Join-Prune Holdtime: 350
Keepalive Period: 210
Assert Time: 210
Register Suppression Time: 60
Register Probe Time: 5
Register TTL: 64
SSM enabled, range default
Sparse-Mode Graceful Restart Duration: 30
Graceful restart is complete (timer 0 seconds)
Join filter, access-list bronze
Designated Router Priority: 2
• See show ipv6 pim.
show ipv6 pim bsr
• Use to display BSR information and the group prefixes for which the local router is a
candidate RP in a PIM sparse mode environment.
• Field descriptions
• Candidacy—Whether or not the router is a candidate BSR
• Configured on—Interface on which the router is configured
• address—Address of the router
• hashMaskLen—Hash mask length
• priority—Priority of the router
• period—Time between bootstrap messages
• Elected BSR—“ this router” or IP address of the elected bootstrap router
• next BSM—If BSR is “ this router,” time until the next bootstrap message is sent
Copyright © 2010, Juniper Networks, Inc.224
JunosE 11.2.x Multicast Routing Configuration Guide