• Interface Addr—IPv6 address of the interface
• Interface Name—Type and identifier of the interface. For details about interface
types and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
• Ver—Version of PIM running on this interface
• Mode—PIM mode running on this interface: Sparse
• Nbr Count—Number of neighbors connected to this interface
• Hello Intvl—Time interval at which the interface sends hello messages to neighbors
• J/P Interval—Total number of join/prune message interval, in seconds, at which the
interface sends the join/prune messages
• DR Address—Address of the designated router
• SM—Number of PIM sparse mode interfaces
• enabled—Number of interfaces administratively enabled
• disabled—Number of interfaces administratively disabled
• DR Pri— Designated router priority value
• ControlPkt Count In | Out—PIM messages received on and sent from this interface
• Hello—Number of hello messages
• JoinPrune—Total number of join and prune messages
• Assert—Number of assert messages
• Example 1
host1# show ipv6 pim interface
PIM Interface Table
Interface Addr Interface State Ver Mode Nbr Hello J/P DR DR Addr JoinFilter
Count Intvl Intvl Pri
101::1 ATM2/0.100 Up 2 Sparse 1 30 150 5 101::2 -
102::1 ATM2/0.101 Up 2 Sparse 1 30 100 2 102::2 silver
103::1 ATM3/0.102 Up 2 Sparse 1 30 100 2 103::1 gold
• Example 2
host1#show ipv6 pim interface summary
PIM Interface Summary
SM: 0, 0 enabled, 0 disabled
• Example 3
host1#show ipv6 pim interface count
PIM Interface Count
Interface Addr Interface Name ControlPktCount In|Out
Hello JoinPrune Assert
Copyright © 2010, Juniper Networks, Inc.226
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...