Juniper JUNOSE 11.2.X MULTICAST ROUTING - Page 252

• Example
host1:2#show ipv6 pim sparse-mode sg-state
PIM SM route table and oif information
<*, ff0e::1:3>
Group-to-RP mapping: ff00::/12 RP: ::123:1
RPF Route: ::123:1/96 IIF: :106:73 UpNbr: ::106:37
Oifs:
Address: ::78:7:7 Interface: loopback7
Local group membership present.
<*, ff0e::a:1>
Group-to-RP mapping: ff001:/12 RP: ::123:1
RPF Route: :123:1/96 IIF: :106:73 UpNbr: :106:37
Oifs:
Address: ::78:7:7 Interface: loopback7
Local group membership present.
<::118:34, ff3e::1>
SSM Group
RPF Route: ::118:0/96 IIF: :118:1 (Directly attached)
Oifs:
Register Oif to RP: ::141:2 suppressed for SSM Group.
Address: ::134:1 Interface: ATM3/0.104
Joined as <S, G> Join Expires: 161
<::118:35, ff3e::1>
SSM Group
RPF Route: ::118:0/96 IIF: ::118:1 (Directly attached)
Oifs:
Register Oif to RP: ::141:2 suppressed for SSM Group.
Address: ::134:1 Interface: ATM3/0.104
Joined as <S, G> Join Expires: 161
<::10:8, ff0e::5:1> EntryExpires: 143
Group-to-RP mapping: ff00::/12 RP: ::123:1
RPF Route: ::10:0/96 IIF: ::106:73 UpNbr: ::106:37
Oifs:
Address: ::78:7:7 Interface: loopback7
Joined as <*, G>
Count of entries - <S, G> : 3
<*, G> : 2
<*, *, RP>: 0
• See show ipv6 pim sparse-mode sg-state
show ipv6 pim sparse-mode unicast-route
• Use to display the unicast routes that PIM sparse mode is using.
• Field descriptions
• Route—IPv6 address and network mask for the unicast route
• RpfNbr—RPF neighbor
• Iif—Incoming interface for the unicast route
• Pref—Preference for the unicast route
• Metric—Value of metric for the unicast route (type of metric varies with the unicast
protocol)
• Count of entries—Number of unicast routes that PIM sparse mode is using.
Copyright © 2010, Juniper Networks, Inc.230
JunosE 11.2.x Multicast Routing Configuration Guide