Juniper JUNOSE 11.2.X MULTICAST ROUTING - Page 253

• Example
host1:2#show ipv6 pim sparse-mode unicast-route
PIM SM unicast route table information
Route RpfNbr Iif Pref Metric
---------------------------------------------------------------------------
::122:0 /96 ::122:1 255 1
Count of entries: 1
• See show ipv6 pim sparse-mode unicast-route
show ipv6 pim spt-threshold
• Use to display the threshold for switching to the shortest path tree at a PIM designated
router.
• Field descriptions
• Access List Name—Name of the IPv6 access list that specifies the groups to which
the threshold applies
• SptThreshold (in kbps)—Value at which PIM sparse mode should switch from a
shared tree to an SPT. A value of infinity indicates that PIM sparse mode should
never switch to an SPT.
• Example
host1:2#show ipv6 pim spt-threshold
Access List Name SptThreshold(in kbps)
-------------------------------------------------------
1 infinity
• See show ipv6 pim spt-threshold.
231Copyright © 2010, Juniper Networks, Inc.
Chapter 7: Configuring PIM for IPv6 Multicast