• Use to display statistics for packets received through multicast routes that the router
has added to the multicast routing table and established on the appropriate line
modules.
• Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
• Field descriptions
• See the show ip mroute command for descriptions of all fields except the Statistics
field.
• Statistics
NOTE: The display shows statistics after the VR has added the multicast route to the
multicast routing table and established the route on the appropriate line module.
Statistics for interactions that take place before the route is established on the line
module are not displayed.
• Received—Number of packets and bytes that the VR received for this multicast
route
• Forwarded—Number of packets and bytes that the VR has forwarded for this
multicast route
• Rcvd on OIF—Number of packets that the VR has received on the outgoing interface
(OIF) for this multicast route
• Example
host1#show ip mroute statistics
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.1.9, 225.1.1.1) uptime 0 00:00:23
Admission bandwidth: 2000000 bps
QoS bandwidth: 2000000 bps
RPF route: 10.0.0.0/8, incoming interface ATM2/1.200
neighbor 21.1.1.1, owner Netmgmt
Incoming interface list:
ATM2/1.200 (21.2.2.2/8), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/1.300 (31.2.2.2/8), Blocked (port-adm-limit)/Pim, 0
00:00:23/never
Statistics:
Received : 23 pkts, 1472 bytes
Copyright © 2010, Juniper Networks, Inc.34
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...