Forwarded : 0 pkts, 0 bytes
Rcvd on OIF: 0 pkts
Counts: 1 (S, G) entries
0 (*, G) entries
• See show ip mroute.
• See statistics.
show ip mroute summary
• Use to display a summary of all or specified multicast routes.
• Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
• Field descriptions
• Group Address—IP address of the multicast group
• Source Address—IP address of the multicast source
• RPF route—IP address and network mask of the RPF route
• RPF Iif —Type and identifier for the incoming interface for the RPF route
• #Oifs—Number of outgoing interfaces
• Counts—Numbers of types of (S,G) pairs
• (S,G)—Number of (S,G) entries
• (*,G)—Number of (*,G) entries
• Example
host1#show ip mroute summary
IP Multicast Routing Table
Group Address Source Address RPF route RPF Iif #Oifs
--------------- --------------- --------- ------------- ----
224.0.1.39 52.1.1.1 51.1.1.1/32 Register IIF 0
224.0.1.40 51.1.1.1 51.1.1.1/32 loopback1 1
Counts: 2 (S, G) entries
0 (*, G) entries
• See show ip mroute.
show ip multicast protocols
• Use to display information about multicast protocols enabled on the router.
• Use the brief option to display a summary of information rather than a detailed
description.
• Field descriptions
35Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring IPv4 Multicast
To Next Page
Loading...