Unpacking and Mounting the SRX380
IN THIS SECTION
Unpacking the SRX380 Services Gateway | 37
Verifying Parts Received with the SRX380 Services Gateway | 38
Mounting the SRX380 Services Gateway in a Rack | 39
Unpacking the SRX380 Services Gateway
The SRX380 Services Gateway is shipped in a cardboard carton and secured with foam packing material.
The carton also contains an accessory box and quick start instructions.
NOTE: The services gateway is maximally protected inside the cardboard carton. Do not unpack
it until you are ready to begin installation.
To unpack the SRX380 Services Gateway:
1. Move the cardboard carton to a staging area as close to the installation site as possible, where you
have enough room to remove the components from the chassis.
2. Position the cardboard carton with the arrows pointing up.
3. Carefully open the top of the cardboard carton.
4. Remove the foam covering the top of the services gateway.
5. Remove the accessory box.
6. Verify the parts received against the lists in “Verifying Parts Received with the SRX380 Services
Gateway” on page 38.
37
To Next Page
