Juniper SRX380 - Required Tools and Parts for Packing the SRX Series Services Gateway; Packing the SRX Series Services Gateway for Shipment

Required Tools and Parts for Packing the SRX Series Services Gateway
To remove one or more components from the SRX Series Services Gateway or to remove the services
gateway from a rack, you need the following tools and parts:
•
Electrostatic bag or antistatic mat for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade screwdriver, approximately 1/4 in. (6 mm)
•
Phillips (+) screwdrivers, numbers 1 and 2
Packing the SRX Series Services Gateway for Shipment
To pack the SRX Series Services Gateway for shipment:
1. Retrieve the shipping carton and packing materials in which the services gateway was originally shipped.
If you do not have these materials, contact your Juniper Networks representative about approved
packaging materials.
2. Wrap and fasten an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the
strap to the ESD point on the chassis or to an outside ESD point if the device is disconnected from
earth ground.
3. On the console or other management device connected to the services gateway, enter CLI operational
mode, and then shut down the services gateway software:
user@host> request system halt
Wait until a message appears on the console confirming that the operating system has halted.
4. Shut down power to the services gateway by pressing the Power button on the front of the services
gateway.
5. Disconnect power from the services gateway.
6. Remove the cables that connect to all external devices.
7. If the device is installed on a wall or rack, have one person support the weight of the device while
another person unscrews and removes the mounting screws.
8. Place the services gateway in the shipping carton.
72