Juniper SRX380 - Configure the SRX380 Using J-Web

2. Connect the LAN network to any of the ports from 0/1 through 0/18.
3. Check to see if the SRX380 is connected to the Internet. Go to http://www.juniper.net. If the page
does not load, check the Internet connection.
After you complete these steps, you can start using the SRX380 on your network right away. You can go
back and customize settings at anytime. The J-Web Setup wizard is always available to you.
Configure the SRX380 Using J-Web
You can modify the configuration using J-Web. Have the following information ready before you start the
configuration process:
•
Hostname
•
Root authentication password
•
IP address for the NTP server
•
IP address for the DNS server
•
IP address for the management interface
52