Juniper SRX380 - Removing and Installing Mini-Pims; Remove a Mini-Physical Interface Module

Removing and Installing Mini-PIMs
IN THIS SECTION
Remove a Mini-Physical Interface Module | 65
Install a Mini-Physical Interface Module | 66
Before you begin, power off the services gateway.
CAUTION: The Mini-Physical Interface Modules (Mini-PIMs) are not hot-swappable.
You must power off the services gateway before removing or installing Mini-PIMs.
To maintain proper airflow through the services gateway, cover any empty Mini-PIM slot with a blank
faceplate.
CAUTION: Do not remove a blank faceplate that covers an empty Mini-PIM slot unless
you are installing a Mini-PIM in the empty slot.
Remove a Mini-Physical Interface Module
To remove a Mini-PIM from the services gateway (see Figure 21 on page 66):
1. Place an electrostatic bag or antistatic mat on a flat, stable surface on which you intend to place the
Mini-PIM.
2. Wrap and fasten one end of the ESD grounding strap around your wrist and connect the other end to
a site ESD point.
3. Unplug the power adapter from the services gateway.
4. Verify that the Power LED is off.
65