Juniper SRX380 - Configuring Junos os on the SRX380; Configure Root Authentication

After the connection is established, the Mini-USB Type-B console port becomes the active console port.
The host machine connected to the Mini-USB Type-B console port displays log messages and enables you
to control the device functionality through it.
Configuring Junos OS on the SRX380
IN THIS SECTION
Configure Root Authentication | 50
Plug and Play | 51
Configure the SRX380 Using J-Web | 52
Configuring the SRX380 Services Gateway Using CLI | 54
The services gateway is shipped with the Juniper Networks Junos operating system (Junos OS) preinstalled
and ready to be configured when the device is powered on. You can perform the initial software
configuration of the services gateway by using any one of the following methods:
•
J-Web Setup wizard
•
Command-line interface (CLI)
Configure Root Authentication
To configure root authentication:
1. Connect one end of the Ethernet cable to the management port (labeled MGMT) on the device.
NOTE: You can also connect any of the network ports numbered 0/1 through 0/15 to the
Ethernet port on the management device.
2. Connect the other end of the Ethernet cable to the management device.
50