•
Forced shutdown—Press the Power button and hold it down for 10 seconds. The device immediately
powers itself off without shutting down the operating system.
CAUTION: Forced shutdown can result in data loss and corruption of the file system.
Use the forced shutdown method as a last resort to recover the services gateway if
the services gateway operating system is not responding to the graceful shutdown
method.
WARNING: Do not press the Power button while the device is shutting down.
To remove power completely from the device, unplug the power cord or switch off the AC power source.
After powering off a power supply, wait at least 10 seconds before turning it back on. After powering on
a power supply, wait at least 10 seconds before turning it off.
The Power button on the services gateway is a standby power switch, which will not turn off the input
power to the services gateway.
TIP: When you are powering off the device, the CLI displays the following message: Turning
the system power off. You can now safely remove the power cable to completely power off the
device.
NOTE: You can use the request system reboot CLI command to schedule a reboot.
46
To Next Page
