Troubleshooting/Appendix
EN I
125
Timer Programming
Dubbing
Disc
Message Advice
HDD CAN NOT SET TIMER PROGRAMME DUE
TO SHORTAGE OF CAPACITY
DELETE UNWANTED TITLE OR CHANGE
RECORD MODE
There is no recordable space remaining in the hard disk.
Increase the recordable space by dubbing the currently
recorded programmes to DVD first, then delete the
programmes. [ P88]
CAN NOT PERFORM TIMER RECORDING
CHECK PROGRAMME LIST TO CONFIRM
For HDD timer programming, there are timer programmes
that cannot be recorded within the duration set due to the
remaining capacity of HDD. Verify, cancel or change the
timer programme from the programme list where
necessary. [ P57]
HDD/DVD SET CLOCK BEFORE TIMER
PROGRAMMING
Set the clock. [ P34]
Message Advice
HDD/DVD CAN NOT DUB DURING RECORDING
STOP RECORDING THEN RETRY
Dub after recording ends.
THE i.LINK DEVICE THAT YOU HAVE
CONNECTED IS NOT RECOGNIZED
MAKE SURE THAT DEVICE IS CONNECTED
PROPERLY AND POWERED ON
Check that the DV device is correctly connected to the DV
input terminal on the unit’s front panel.
Message Advice
DVD COULD NOT CANCEL DISC FINALISATION
CHECK THE DISC
The disc may be dirty. Clean the disc and try again.
COULD NOT FINALISE THE DISC
CHECK THE DISC
COULD NOT FORMAT THE DISC
CHECK THE DISC
DR-MX10SE.book Page 125 Wednesday, December 14, 2005 3:37 PM
To Next Page
Loading...
Need help?
General
