H EN
78
Dubbing from VHS to HDD
or DVD (1 Programme)
A Load the tape to play.
0 When dubbing to a DVD disc, load a recordable
disc.
B Select “VHS
N
HDD” or “VHS
N
DVD” in step B of “Dubbing between
HDD and DVD Deck”, then select “1
PROG.”. [ P72]
C Set the recording mode.
A Select the recording mode.
B Select ACONFIRMB.
0 See ARecording ModeB [ P92]
D Pause playback at the scene that you
wish to dub.
0 Locate the recording start point with O/N,
then pause playback.
E Select “EXECUTE”.
If the index signal (VISS) of the VHS is
detected, dubbing ends, and the
broadcast screen appears automatically
after a message is displayed.
To cancel a dubbing that is in progress
A
Press STOP/CLEAR ( o).
B Select ACANCELB, then press ENTER.
ABCDEFGHILM
9 Dubbing only one of the programmes
recorded on a VHS tape to the HDD or a
DVD disc is possible.
........................................................
NOTES:
0 When the HDD or DVD disc runs out of disc
remaining time, the tape will automatically stop at
that position and dubbing will cease.
If dubbing to DVD-RW/-R (Video mode)
0 For discs in Video mode, switching of audio during
playback is not possible.
Set to AMAINB or ASUBB in the Setup menu
[ P111] N.
STOP
CANCEL
B, C, E
D
SELECT
CONFIRM
SP
CONFIRM
SELECT
CONFIRM
SELECT
CONFIRM
EXECUTE
DR-MX10SE.book Page 78 Wednesday, December 14, 2005 3:37 PM
To Next Page
Loading...
Need help?
General
