Basic Operations
EN I
53
D If necessary, set recording options
for timer programming.
A Select AINPUT TITLEB to enter the title
name.
0 See ACreating Programme TitleB [ P82].
0 The title can be set later.
B Select ACATEGORYB to set the category.
0 See AModify CategoryB [ P81].
0 The category can be set later.
C Select and confirm on AVPS/PDCB.
0 See AVPS/PDC RecordingB [ P55].
D Select AW E EK LY / DA ILY B to set the
recording frequency.
0 See AWeekly/Daily Timer ProgrammingB
[ P94].
E Select AREC MODEB to set the recording
mode.
0 See ARecording ModeB [ P92].
E Select “OK”.
0 If timer programmes overlap, a warning message
will be displayed.
F Select “EXIT”.
To continue with other timer programmings, select
ACONTINUEB, then repeat step B-F.
0 Press STANDBY/ON to turn off when not performing
other operations.
To timer record using VPS/PDC
G Press VPS/PDC
j
.
0 This unit turns off automatically and enters into
recording standby mode.
0 e lights up on the front display panel indicating
that VPS/PDC recording is activated.
When programming content overlaps
0 When completing the setting, if a message on
programme overlap is displayed, cancel the timer
programme, or change the programmed time, etc.
0 See AChecking, Changing or Cancelling a Timer
ProgrammeB [ P57].
........................................................
NOTE:
0 If you do not cancel the timer programme or change
the programmed time, the programme whose start
time is earlier will be recorded first until it ends, then
the next programme will be recorded unless it has
ended.
OK
INPUT TITLE
CATEGORY
VPS/PDC
WEEKLY/DAILY
REC MODE
OFF
WEEKLY
SP
SELECT
CONFIRM
EXIT
SELECT
CONFIRM
(Warning message on
programme overlap)
PROGRAMME NOT COMPLETED
PROGRAMME OVERLAPPED
PLEASE CONFIRM AND MODIFY
OK
DR-MX10SE.book Page 53 Wednesday, December 14, 2005 3:37 PM
To Next Page
Loading...
Need help?
General
