Kaba access manager 92 30 User Manual

Start-up Technical Manual
72 04045376 - 05/2016 Kaba access manager 92 30
6.3.2 Perform a cold start and set the default IP address 123.0.0.2
When performing a cold start, parameters are reset to their default values. Master
records and booking records are deleted.
1. Turn off the device.
2. Turn on the device.
ð The yellow status LED is lit.
ð After approx. 40 seconds, the yellow status LED starts flashing.
3. Within 10 seconds, press the reset key and keep it depressed.
ð The status LED flashes faster for 5 seconds.
ð The status LED lights up in green for 2 seconds.
ð A cold start was performed.
ð The status LED lights up briefly in red and then flashes in red for 5seconds.
ð The status LED flashes in green for 2 seconds.
ð The default IP address 123.0.0.2 has been set.
4. Release the reset key again.
ð The status LED is lit in green.
ð The system is ready for use, a cold start was performed, and the default IP ad-
dress 123.0.0.2 was set.
6.3.3 Setting the default IP address 123.0.0.2 (without cold start)
1. Turn off the device.
2. Turn on the device.
ð The yellow status LED is lit.
ð After approx. 40 seconds, the yellow status LED starts flashing.
ð After another 10 seconds, the red status LED is lit.
3. Within 5 seconds, press the reset key and keep it depressed.
ð The status LED flashes faster for 5 seconds.
ð The status LED flashes green for 2 seconds.
ð The default IP address 123.0.0.2 has been set.
4. Release the reset key again.
ð The green status LED is lit.
ð The system is ready for use, the default IP address 123.0.0.2 was set.

Kaba access manager 92 30 Specifications

General

Brand	Kaba
Model	access manager 92 30
Category	Wireless Access Point
Language	English