30
Programming
Program the Lock with at least one user with the Privacy/Deadbolt Override
privilege, and one user without this privilege, using the Oracode Maintenance
Unit.
Generate valid codes for these 2 users. (Recommendation: generate codes that
starts a day before today and finishes at least one day after current date, in
order to avoid check-in/check-out time periods)
Code entry and access
With the Deadbolt/Privacy deactivated, enter the first code to validate com-
plete lock operation.Verify that the green LED flashes at each key pressed and
a longer green LED flash at the end of the code entry. Turn the outside lever.
Make sure the latch bolt retracts fully. Release the lever, wait for the lock to
return to the locked mode (default settings is 5 seconds after unlocking), and
then turn the lever again.
The latch bolt must not retract after the lock has returned to locked mode,
which is typically 5 seconds (max 15 sec) after unlocking, without first entering
a valid user code.
Repeat with the second code.
Emergency Access(Deadbolt Override)
After programming turn the thumb turn to the horizontal position to engage
the Deadbolt/Privacy feature.
Deadbolt/Privacy engaged, access denied:
Enter the user code that does not have the Deadbolt/Privacy Override privi-
lege. Instead of the normal sequence of indicator LED with the green LED
flashing once indicating a valid code, this will be followed by a single red LED
flash, indicating access denied. Turn the outside lever, latch should not retract.
Access denied. If you see only the green LED flash once and /or the latch
retracting there might be a problem with the deadbolt/Privacy switch, or you
may have used a code with a Deadbolt/Privacy override privilege. Verify
thumbturn position. It should be vertical.
Emergency access: Deadbolt/Privacy engaged, user code with override privi-
lege, access granted: Enter the user code that has the Deadbolt/Privacy
Override privilege. You should see the normal sequence of indicator LED:
green LED flashes once. Turn the outside lever ,the latch and deadbolt retracts
simultaneously and fully: Access granted. If you see the red LED and no Latch
bolt retraction, verify that the code used has the deadbolt/privacy override
privilege enabled. Turn the thumb turn back to the vertical position if not
already so.
To Next Page
Loading...
Need help?
General
