KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
3.2.2 Setting the Temperature
The target temperature is entered from the default view.
Press ESC or do not use the KaController for 3 seconds to call up the
default view.
Setting the temperature setpoint:
A new temperature setpoint can be entered by turning the
navigator in the standard view. The figure is applied by pressing the
navigator and the default view is called up.
If no action is carried out using the navigator or function keys for
3 seconds, then the last change made is saved and the default
view is called up again.
Venkon
12
Default view
Temperature
setpoint setting
To Next Page
Loading...
