KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
Venkon
53
10.4 Programming Key
Programming Key
After the parameters have been set, setup can be simply copied to
other Venkon circuit boards with the aid of the programming key.
Please follow the following steps to copy setup:
1. Disconnect the previously programmed Venkon KaControl circuit
board.
Read parameters
2. Set the DIP switch of the programming key to Read mode
(DIP1 =OFF, DIP20 =OFF). The DIP switches are located
underneath the cover!
3. Plug the key into the 8-pin plug labelled IR on the Venkon circuit
board using the adapter cable.
4. Press the button on the programming key. If the copy is
successful, the red LED will light up followed by the green LED.
Loading parameters
5. Remove the programming key and set the internal DIP switches
of the programming key to Write mode (DIP1=OFF, DIP2=ON).
6. Repeat steps 3 and 4 to write the parameters to the Venkon
circuit board.
Important note:
The new Venkon circuit board should also be disconnected before
writing the parameters.
The programming key is not supplied as standard with the unit
and can be ordered from Kampmann Customer Service as a
non-standard accessory.
The software versions of the control circuit boards must be
identical when reading and writing the parameter sets (see
parameter P000).
It is not possible to read parameters from a control board using
software version "P000=33" for instance and then write the
parameters to a control board using software version "P000=37".
To Next Page
Loading...
