KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
2. Important Information / Safety Information
Installation, assembly and maintenance work on electrical units
should only be performed by a qualified electrician (in compliance
with VDE requirements).
Wiring should comply with applicable VDE regulations and
provisions laid down by regional electricity providers. Non-
adherence to these regulations and the operating manual can lead
to malfunction of the unit with consequential damage and resulting
danger to personnel. There is a risk of fatal injury if wiring is not
correct or wires are crossed! All parts of the system should be
disconnected from the power source before commencing with
wiring or maintenance work and should be prevented from
accidental re-connection!
Please read this manual in full to guarantee correct installation and
trouble-free operation of the KaController.
Please note the following safety-relevant information:
• Disconnect all parts of the system that are being worked on.
• Ensure that the system cannot be accidentally re-connected!
• Before commencing with installation/maintenance work, wait
until the fan has come to a standstill once the unit has been
switched off.
• Caution! Pipes, casings and fittings can become very hot or very
cold depending on the mode of operation!
• Specialist personnel must have adequate knowledge, obtained in
their training, of:
•• Safety and accident prevention regulations
•• Guidelines and recognised technical regulations, i.e. Associati-
on of German Electricians (VDE) regulations,
•• DIN and EN standards.
•• Accident prevention regulations VBG, VBG4, VBG9a
•• DIN VDE 0100, DIN VDE 0105
•• EN 60730 (Part 1)
•• Technical wiring regulations (TABs) issued by the regional
electricity providers.
During installation, the products should be protected against
moisture. In case of doubt, discuss the application directly with the
manufacturer. Any use other than the uses specified above is
deemed not to be correct and proper use. Any damage resulting
from this is the sole responsibility of the operator of the unit.
Correct and proper use is also deemed to include compliance with
the installation instructions described in this manual.
Modifications to the unit
Do not undertake any modifications, renovations or additions to
the KaController or Venkon unit without discussing these with the
manufacturer as this could impair the safety and correct operation
of the units.
Do not undertake any work on the unit that is not described in this
manual. On-site systems and cabling must be suitable for
connecting to the intended system!
Venkon
6
To Next Page
Loading...
