Kampmann KaControl - 12 Functional Testing of Connected Assemblies

KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
Venkon
58
12. Functional Testing of Connected Assemblies
The KaController provides the option of checking the operation of
the connected external units independently of the software
application.
The function of individual assemblies, such as the fan, can be
directly enabled and checked using inputs on the KaController.
The functional test of the connected assemblies is called up and
implemented by the following operating steps:
1. Switch off the Venkon by:
• Pressing the ON/OFF key or
• Pressing the navigator for a minimum of 5 seconds or
• Turning the navigator to the left until OFF appears
2. Call up the Parameter menu by pressing the navigator for a
minimum of 10 seconds. The display shows "Para" and then "CODE"
with the value 000 in sequence.
3. Select the password (Code) 77 by turning the navigator and
confirm by pressing the navigator.
4. "L01" is shown on the display and the function test of the
connected assemblies can start.
Important note:
The individual test steps are called up by pressing the navigator.
The default view with "OFF" on-screen display is shown once the
test has been completed (L15).