Kampmann KaControl - Continuous Fan Mode; Automatic Mode Settings in 4-Pipe Systems

10.3.12.3 Continuous Fan Mode
Parameter P29 can be used to activate Continuous fan mode. In Continuous fan mode, the fan
remains switched on at the preset fan stage, even if the room temperature has reached the target
figure (in Automatic fan mode Stage 1 remains active).
Parameter P29
Parameter P29 is used to set continuous fan mode.
10.3.13 Automatic Mode Settings in 4-Pipe Systems
In 4-pipe systems, the controller automatically specifies the operating mode in Automatic mode
according to the room temperature and the set target value.
Automatic mode can be set using parameters P02, P03, P04 and P05.
KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
Venkon
51
Operation Standard Min Max Unit
P29 0=Continuous fan mode disabled
1=Continuous fan mode enabled
0 0 1
Operation Standard Min Max Unit
P02 see Figures 5 0 255 °C /10
P03 see Figures 5 0 255 °C /10
P04 see Figures 10 0 255 °C /10
P05 see Figures 3 0 255 °C /10
Automatic mode in
4-pipe systems