KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
View of "Motor fault" alarm
View of "Realtime fault
in KaController"
4. Alarm Messages
The KaController displays fault messages using the alarm messages
given in the table below. The alarm messages are displayed
according to their priority. In the event of an alarm, note down the
alarm message and contact the responsible member of staff (System
Administrator or Installed/Service Technician) to remedy the cause
of the fault.
4.1 Venkon
Venkon alarm table
4.2 KaController Control Electronics
KaController control electronics alarm table
Should more than one fault occur simultaneously with the
KaController control electronics, the alarm messages are
displayed alternately in the display.
Venkon
19
Code Alarm Priority
A01 EEPROM fault 1
A03 Room sensor fault 2
A04 B2 or B3 sensor fault 3
A06 Condensation alarm 4
A07 Motor fault 5
Code Alarm
tAL1 Temperature sensor fault in KaController
tAL3 Realtime fault in KaController
tAL4 EEPROM fault in KaController
Cn Communication fault with the ext. control PCB
To Next Page
Loading...
