3.2.5 Timer Programs
The KaController offers the option of programming on and off times
using a timer program if rooms are only to be air conditioned during
certain times of the day. Unlike with conventional thermostatic
controllers, it is not only possible to set one on and off time each day,
but two on and off times per day.
Set the time in the "Time setting" selection menu before
parameterizing the on and off times.
The KaController can manage 2 switching on and 2 switching off
times per day. The on and off times can be entered as a block for the
entire week or entered individually for each day.
The timer program switches the controller on and off in
accordance with the set time intervals. Once the controller has
been switched off by the timer program, the user then has the
option of switching it on again using the ON/OFF key or the
navigator.
If no on or off time is entered into the timer matrix, the "Clock"
symbol is hidden in the default view.
The diagram below shows the sequence for setting the timer
programs. Steps 1-4 are described in more detail in the next section.
To exit the "Timer programs" selection menu, press and hold down
the navigator for 3 seconds in the Timer Start menu or do not
operate the KaController for 15 seconds.
KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
ON1 OFF1 ON2 OFF2
MO 6 : 00 18 : 00 - - : - - - - : - -
TU 6 : 00 18 : 00 - - : - - - - : - -
WE 6 : 00 18 : 00 - - : - - - - : - -
TH 6 : 00 18 : 00 - - : - - - - : - -
FR 6 : 00 18 : 00 - - : - - - - : - -
SA 8 : 00 14 : 00 - - : - - - - : - -
SU - - : - - - - : - - - - : - - - - : - -
Timer matrix
Example of a weekly
timer program
Display elements in the Timer
Programs selection menu
Venkon
15
1 ON= SWITCH ON timer program
OFF=SWITCH OFF timer program
2 1=Timer program no. 1
2=Timer program no. 2
3 Switching on/switching off time
4 Weekday
5 If no on or off time is entered into the timer matrix, the "Clock"
symbol is hidden in the default view.
To Next Page
Loading...
