KaControl for Venkon
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1.48
Step 4:
It is possible to set the switching-off time you require by turning the
navigator.
Once the minutes have been entered, press the navigator to apply
the switching-off time entered and the timer program start screen is
called up (-> Step 1).
The respective day and associated timer program no. must be
called up to delete the switching-on and off times entered
(Step 1 + Step ). The switching-on or off time entered should be
replaced by "--:--" (Step 3 + Step 4).
Important note: The block-wise deletion of timer entries is not
possible!
Timer entries can be overwritten at any time and this can be done
for a block as well as for each day.
Switching-on and off times should only be requested singly for each
day. The block-wise requesting of switching-on and off times is not
possible with different timer entries for the respective weekdays
and the time is displayed with "--:--"!
To exit the "Timer programs" selection menu, press and hold
down the navigator for 3 seconds in the Timer Start screen or do
not perform any operation on the KaController for 15 seconds.
Venkon
17
Input screen for
switching-off time
To Next Page
Loading...
