Kamstrup ULTRAFLOW 54 User Manual

TECHNICAL DESCRIPTION ULTRAFLOW
®
54 and 34
5512-385 GB/02.2014/Rev. H1
15
4.7 Accessories for Pulse Transmitter and Pulse Divider
Please note that not all article numbers in Table 10 can be directly ordered. Some must be ordered via Kamstrup
service department
65-000-000-2000 D-cell lithium battery with two-pole connector
3026-477
1)
Fitting for D-cell battery
Enclosed if battery supply
or “No supply” is selected
1650-157
1)
Plug for cable connection
Enclosed if battery supply
or “No supply” is selected
65-000-000-7000
2)
230 VAC supply module
65-000-000-8000
2)
24 VAC supply module
5000-290 Cable between supply module and output module
Enclosed if supply module
is selected
5000-286 24/230 VAC power cable Optional
66-99-012 Output module (Y=2), galvanically separated
66-99-013
Output module (Y=3), galvanically separated,
“Low power”
5000-333 2.5 m silicone cable (3-wire) Optional
5000-259 5 m silicone cable (3-wire) Optional
5000-270 10 m silicone cable (3-wire) Optional
3026-207 Bracket for wall munting Optional
Article number Description
Note
(when ordering Pulse
Transmitter/Pulse Divider)
1)
Obligatory when changing from mains supply module to battery supply.
2)
Including 5000-290.
Table 10. Accessories for Pulse Transmitter and Pulse Divider.
4.7.1 Cables
Pulse Transmitter and Pulse Divider are optionally available with signal cable in lengths of 2.5, 5 or 10 metres. The
signal cable is mounted from the factory.
If 24/230 VAC supply module is selected, Pulse Transmitter and Pusle Divider are optionally available with mains
supply cable. The cable is mounted from the factory.

Kamstrup ULTRAFLOW 54 Specifications

General

Brand	Kamstrup
Model	ULTRAFLOW 54
Category	Measuring Instruments
Language	English