KEB COMBIVERT F5

136
ru.29
Analog pre-
torque raw
ru.30
Analog
pre-torque
processed
This parameter displays the value of the actual pre-torque signal applied between
terminal X2A.3 and X2A.4. The value is in percent +/- 100.0% = +/- 10.00V. This
value is un ltered and unprocessed.
Units: %
This parameter displays the processed analog pre-torque value. Filters, offsets and
gains are applied to this value. Again 100.0% = 10.00V on the input.
Units: %
This parameter displays the value of the analog signal applied to an option interface
board. Again +/- 100.0% = +/- 10.00V. This value is un ltered and unprocessed.
Units: %
This parameter displays the processed analog option value. Filters, offsets and
gains are applied to this value. Again 100.0% = 10.00V on the input.
Units: %
Analog output 1 preamp display. The value is in percent +/- 100.0% = +/- 10.00V.
Units:%
Analog output 1 post amp display. The value is in percent +/- 100.0% = +/- 10.00V.
Units:%
Analog output 2 preamp display. The value is in percent +/- 100.0% = +/- 10.00V.
Units:%
Analog output 2 post amp display. The value is in percent +/- 100.0% = +/- 10.00V.
Units:%
ru.31
Analog option
raw
ru.32
Analog option
processed
ru.33
Analog Out 1
preamp
ru.34
Analog Out 1
post-amp
ru.35
Analog Out 2
preamp
ru.36
Analog Out 2
post-amp
Diagnostic Parameters