146
9.1 Digital Input Parameters
9.0 Input/Output Con guration
The digital input parameters can be used to con gure the digital
inputs for operation. Normally these parameters only need to be
adjusted by the Elevator control builder.
di. 0
Input Type
Determines whether the inputs are PNP (sourcing) or NPN (sinking). This setting
is applied globaly to all inputs.
Unit: -
Value Range: PnP, nPn
Default Setting: PnP
This parameter controls a digital noise lter which can be used to mask relay bounce
or other unwanted momentary signals. This lter applies to all digital inputs except
the enable input at X2A.16. The enable input is processed immediately.
Unit: mSec
Value Range: 0 ... 127 mSec
Default Setting: 5 mSec
di. 3
Noise Filter
To Next Page
Loading...
