Keithley 263 - J (Self-Test)

IEEE-488 PROGRAMMING
4.7.6 J (Self-test)
Purpose Use J command to perform tests on its read-only memory (ROM).
Format
Jn
PSGNnStSrS JO Perform self-tests
Description Self-Test--When the JO command is sent over the bus, the instrument performs the
ROM test. If the self-test is successful, the self-test error bit in the Ul status word
will be set to 0. Otherwise, a failure will set this bit to 1.
Programming ClClTPLlT 708.; i L ,ir3:iv 5 ! Perform self-tests
Note
416