Saved setups
Use the saved setups commands to save or restore the configurations to or from the nonvolatile
memory of the instrument or an installed USB flash drive. You can use the setup.poweron attribute
to specify which setup is recalled when the instrument is turned on.
createconfigscript() (on page 11-110)
setup.cards() (on page 11-354)
setup.poweron (on page 11-355)
setup.recall() (on page 11-356)
setup.save() (on page 11-356)
Scan
The scan functions and attributes allow you to set up scanning over the remove interface.
scan.abort() (on page 11-308)
scan.add() (on page 11-309)
scan.addimagestep() (on page 11-311)
scan.addwrite() (on page 11-312)
scan.background() (on page 11-313)
scan.bypass (on page 11-314)
scan.create() (on page 11-315)
scan.execute() (on page 11-317)
scan.list() (on page 11-318)
scan.measurecount (on page 11-320)
scan.mode (on page 11-321)
scan.nobufferbackground() (on page 11-322)
scan.nobufferexecute() (on page 11-323)
scan.reset() (on page 11-324)
scan.scancount (on page 11-325)
scan.state() (on page 11-326)
scan.stepcount (on page 11-327)
scan.trigger.arm.clear() (on page 11-327)
scan.trigger.arm.set() (on page 11-328)
scan.trigger.arm.stimulus (on page 11-328)
scan.trigger.channel.clear() (on page 11-330)
scan.trigger.channel.set() (on page 11-330)
scan.trigger.channel.stimulus (on page 11-331)
scan.trigger.clear() (on page 11-332)
scan.trigger.measure.clear() (on page 11-333)
scan.trigger.measure.set() (on page 11-333)
scan.trigger.measure.stimulus (on page 11-334)
scan.trigger.sequence.clear() (on page 11-335)
scan.trigger.sequence.set() (on page 11-336)
scan.trigger.sequence.stimulus (on page 11-336)
To Next Page
Loading...
Need help?
General
