Model 6487 Reference Manual SCPI Reference Tables 14-9
[:DAMPing]
:OHMS Path to control ohms: 3
[:STATe] <b> Enable or disable ohms for SENSe1 data. OFF
[:STATe]? Query ohms SENSe1 data state.
:AVOLtage Path to A-V ohms commands: 3
[:ARM] Arm A-V ohms mode.
[:ARM]? Query if A-V ohms is armed.
(1 = armed).
:ABORt Abort A-V ohms mode.
:VOLTage <NRf> Set high voltage value (-505 to 505V). 10V
:VOLTage? Query high voltage value.
:TIME <NRf> Set time interval for each phase. 15s*
:TIME? Query time interval for each phase.
:POINts? Query number of points.
:ONEShot <b> Enable or disable one-shot mode. ON
:ONEShot? Query state of one-shot mode.
:CYCLes <NRf> Set number of A-V cycles (1 to 9999). 3
:CYCLes? Query number of A-V cycles.
:UNITs <name> Select AMPS or OHMS units. AMPS
:UNITs? Query units.
:CLEar Clear A-V ohms buffer.
:AUTO <b> Enable/disable A-V buffer auto clear. ON
:AUTO? Query auto clear state.
:BCOunt? Query number of A-V cycles that have
been completed and are averaged to make
up present buffer.
*15s for 1 PLC or greater, 1s for 0.1 PLC, and 0.1s for 0.02 PLC.
Table 14-4 (cont.)
SENSe command summary
Command Description
Default
parameter
Ref.
Section
SCPI
To Next Page
Loading...
