Keithley 6487 - Connections; Model 6485 Input Connector and Levels; Model 6487 Input Connector and Cables; Basic DUT Connections

7 Triggering
Trigger models ............................................................................ 7-2
Idle and initiate .................................................................... 7-4
Trigger model operation ...................................................... 7-5
Trigger model configuration — front panel ........................ 7-8
SCPI programming ................................................................... 7-10
Programming example ...................................................... 7-11
External triggering .................................................................... 7-12
Input trigger requirements ................................................. 7-12
Output trigger specifications ............................................. 7-13
External trigger example ................................................... 7-13
8 Limit Tests and Digital I/O
Limit testing ................................................................................ 8-2
Binning ....................................................................................... 8-5
Component handler interface .............................................. 8-7
Component handler types .................................................... 8-8
Digital output clear pattern ................................................ 8-10
Digital I/O port ......................................................................... 8-11
Sink mode — controlling external devices ....................... 8-12
Source mode — logic control ............................................ 8-14
Setting digital output lines ................................................. 8-14
SCPI programming — digital output pattern .................... 8-15
Front panel operation — limit tests .......................................... 8-16
Limit test configuration ..................................................... 8-16
Performing limit tests ........................................................ 8-17
SCPI programming — limit tests ............................................. 8-18
Programming example ...................................................... 8-21
9 Remote Operation
Selecting and configuring an interface ....................................... 9-2
Interfaces ............................................................................. 9-2
Languages ............................................................................ 9-2
Interface selection and configuration procedures ................ 9-3
GPIB operation and reference .................................................... 9-4
GPIB bus standards ............................................................. 9-4
GPIB bus connections ......................................................... 9-4
Primary address ................................................................... 9-6
General IEEE-488 bus commands ...................................... 9-7
Front panel GPIB operation ................................................ 9-9
Programming syntax ......................................................... 9-10
RS-232 interface reference ....................................................... 9-16
Sending and receiving data ................................................ 9-16